
LANCER TACTICAL ENFORCER NEEDLE-TAIL - RED
Lancer Tactical
LT-29-RED
Stock: 1
Full metal, mosfet, ETU, lightweight Skeleton body for speed
The most important development of the new generation 2 Proline is undoubtedly the original addition of an ETU electronic trigger and a protective mosfet. This trigger allows increased reactivity, a finer trigger stroke sensitivity, protection of the battery voltage, collar gearbox cycles, pre-compression of the spring for a much faster shot start, etc. small revolution, always affordable.
Gearbox:
- Lancer Tactcial Engraved Metal Gearbox Cases
- 18: 1 ratio steel gears
- Delayer
- Bearings 8mm
- 14 teeth steel piston
- Red anodized cylinder for an improved surface finish
- Neodyn 25000rpm magnet hi-speed motor
- QD spring steel guide on bearings
- Spring 1j spring
- Quick spring change (QD)
- Low resistance shielded wiring
- Hi-speed metal trigger
- “Fast trigger” electronic trigger block with increased reactivity and higher rate of fire
- 16AWG shielded wiring (rear)
- Protection Mosfet in the stock tube (battery protection)
Internal parts:
- 6.03mm precision barrel in polished brass
- Hop-up block with central wheel (Gen 2)
- 50 ° hop-up joint
External parts:
- Skeleton type aluminum body (lightened for speed soft)
- External metal barrel
- Foldable sight in Nylin fiber
- Ergonomic metal trigger guard
- M-LOK aluminum handguard
- Single point steel strap clip
- Alpha nylon fiber stock with additional magazine holder location
- Metal stock tube
- False steel cylinder head
- Steel cocking lever with hi-speed handle
- Steel magazine retainer
- Metal bolt catch (fictitious)
- 120 shots metal mid-cap magazine (x2)
- Semi and full auto
In stock